The size is compact
Installing brazing heat exchanger can save 85-90% space and weight compared to the same capacity shell tubular heat exchanger. The brazing heat exchanger occupies 1/10 area of that of the shell tubular heat exchanger. This means each concrete application might have the bigger design freedom - simultaneously reduce the installation cost.
The detention quantity is small
The brazing heat exchanger only has to retain a small part of heat transfer medium, and thus can reduce the capacity cost, and the peripheral system parts may also become smaller, cheaper. In the refrigeration system, low detention quantity is helpful to protect environment.
Material using efficiency is high
Approximately 95% material can be used in heat transfer, and won't form “ the dead area ” outside the gasket, because it does not need the gasket. In the capacity use aspect, it is 25% higher than the assembling heat exchanger with the rubber gasket, and is nearly 10 times of shell tubular heat exchanger!
Performance Calorific performance is extremely good
Because in the brazing heat exchanger it can form highly rapids, it can work under the very small temperature difference, which can bring many advantages. The brazing heat exchanger can still work effectively when the temperature difference reaches as low as 1K.
Environmental heat consumption is low
Because the contour is compact, the synthetic heat loss caused by the convection and the radiation is smaller than all the other similar products.
Because the contour is compact, the synthetic heat loss caused by the convection and the radiation is smaller than all the other similar products.
Truly realize reverse current
This possibility permits using constant temperature measure.
Performance guarantee
Using the helium to carry on the leakage test to the high quality brazing heat exchanger can test the extremely small leakage.
System Installation is simple, and the cost is low
It can choose the position and the size of the connector, together with other functions, for example the special-purpose sensor connector, the air vent, the stud used in installation and so on, which can reduce the installation cost, and reduce the use of expensive parts in the system. This similarly provides each concrete application with the bigger design freedom - simultaneously reduce the installation cost.
Easy to preserve the heat
Compact and smooth surface and design is easy to realize heat preservation, and meantime reduce the cost.
Reduce system cost
The heat transfer coefficient is higher, and can obtain a better temperature difference, which also means lower medium mass flow. In this way, the needed parts (eg. pump) can be smaller, and cheaper, and meantime reduce the energy consumption. Naturally, the cost of whole system can be lowered.
One size—multiple choices
Each type can select different materials with the same size and the heat performance as the standard disposition. Therefore, one doesn't need to change tube and system design regarding different material disposition with different requirement.
The maintenance is little
There is no moving parts or gasket in the brazing heat exchanger. The aged gasket will sooner or later become burst, and has to be replaced. So the gasket not only adds extra cost, but also causes potential leak trouble.
Self cleanness
Brazing heat exchanger internal high rapids design reduces the accumulated filth greatly, speeds up the starting time and reduces the cost. If needed, it can eliminate accumulated filth and the oxide layer by the low cost and efficient way.
Cleanable
The conventional operation usually is sufficient to prevent the accumulated filth. But if necessary, it can use two kinds of low cost and effective ways to clean the brazing heat exchanger: Flushing gun and spot clean.
Reduce stop time as possible as it can
The replacement of brazing heat exchanger only need the few time compared with the replacement or repair of either the shell tubular heat exchanger or the assembling heat exchanger with gasket. This can reduce labor cost and expensive spare parts consumption, and return to operation faster than before.
Production cycle cost
The mass production of brazing heat exchanger and the uniform of products can improve the performance and reduce the cost obviously, which is your economical choice.